IMPORTANT NOTE for SELF INSTALLATION:
*CAUTION: DO NOT POWER UP THE SWITCH WHEN NO WATER SUPPLY.
(WE shall not liable for any malfunction or defect if install by own-self due to not follow instructions or guideline stated here. - Failure to do so shall cause machine malfunction and overheat!)
SETUP INSTRUCTIONS:
STEP 1: PIPING
Use the provided ball valve & feed adapter tap into you water source and piping the tube hose into your water dispenser.
STEP 2: FLUSHING FILTERS
Piping the tube hose to last filter (*post carbon) and flushing for 2-3 minutes to removes carbon powder. Once is done, stop the water supply and re-piping the tube back to water reservoir tank
STEP 3: REFILL FILTERED WATER INTO RESERVOIR TANK
Turn on water supply & FILL UP the Water Reservoir Tank until the water tank is full. Once is full, you can hear the water flow is stopped.
STEP 4: TAKE WATER FROM HOT & COLD TAP.
For initial setup only, you need to press and hold the "HOT WATER TAP" and "SAFETY LOCK" button together to release the pressure & gas, about 2-3 minutes, then hot water will come out from hot tap.
STEP 5: POWER UP & READY TO DRINK
ONCE you have completed STEP 1 – 4, THEN POWER UP THE WATER DISPENSER.
For initial setup Hot water will getting hot within 5 minutes and Cold water will take slightly longer about half an hour.
And you are now ready to enjoy your filtered HOT & COLD water instantly.